M700, PCB REV E, MANUAL TIMING GENERATOR

USE OSCILLOSCOPE TO SEE PULSES.

AE1 IS THE INPUT FOR THE AF1 OUTPUT.
AH1 IS THE INPUT FOR THE AJ1 OUTPUT.
CONNECT AE1 TO EACH TAP:

PINS
 1 I AL2   POWER CLEAR-N
 2 I AS2   FILTER INPUT
 3 I AR2   RESTART-N
 4 I AP2   RUN-N
 5 O AN2   MFTS 0-N  (PULSED, XXuS DELAY FROM AS2 FILTER IN, ???MS WIDE)
 6 O AM2   MFTS 0    (PULSED, XXuS DELAY FROM ?????????????, ???MS WIDE)
 7 O AT2   MFTP 0    (PULSED, XXuS DELAY FROM ?????????????, ???MS WIDE)
 8 O AJ2   MFTS 1    (PULSED, XXuS DELAY FROM ?????????????, ???MS WIDE)
 9 O AK2   MFTS 1-N  (PULSED, XXuS DELAY FROM ?????????????, ???MS WIDE)
10 O AE2   MFTP 1    (PULSED, XXuS DELAY FROM ?????????????, ???MS WIDE)
11 O BD2   MFTP 2    (PULSED, XXuS DELAY FROM ?????????????, ???MS WIDE)
12 O AF2   MFTS 2    (PULSED, XXuS DELAY FROM ?????????????, ???MS WIDE)
13 O AH2   MFTS 2 -N (PULSED, XXuS DELAY FROM ?????????????, ???MS WIDE)

IIIIOOOOOOOOO
0010100010001
; remove POWER CLEAR-N
1
; toggle FILTER INPUT (no action, RUN-N is LO)
 1
 0
; enable with RUN-N HI
   1
; set FILTER INPUT (pulses...)
 1  XXXXXXXXX
 0

needs work

END